Brute Pressure Washer Manuel du propriétaire Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
Generac Portable Products 2100 PSI Pressure Washer
Attach the other end of the high pressure hose to the
high pressure fitting on the pump (Figure 6). Tighten by
hand.
Before you connect your garden hose to the water inlet,
inspect the inlet screen (Figure 7). Clean the screen if it
contains debris, replace it if it is damaged. DO NOT
RUN THE PRESSURE WASHER IF THE
SCREEN IS DAMAGED.
Run water through your garden hose for 30 seconds to
clean out any debris. Turn off water.
IMPORTANT: Do Not siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
Connect the garden hose to the water inlet. Tighten by
hand (Figure 7).
CAUTION! There MUST be at least ten feet of
unrestricted garden hose between the pressure washer
inlet and any flow shut off device, such as a ‘Y’ shut-off
connector or other convenience-type water shut-off valve.
Damage to pressure washer resulting from disregarding this
warning will not be covered by the warranty.
Turn ON the water and squeeze the trigger on the spray
gun to purge the pump system of air and impurities.
CAUTION! Before starting the pressure washer,
be sure you are wearing adequate eye protection.
CHECKLIST BEFORE
STARTING ENGINE
Review the unit’s assembly to confirm you have performed
all of the following:
Make sure the handle and wire form are in place and
secure.
Check that oil has been added to the proper level in the
engine crankcase.
Add the proper gasoline to fuel tank.
Check for properly tightened hose connections.
Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
Provide a proper water supply (not to exceed 100°F) at
an adequate flow.
Be sure to read “Safety Rules” and “How To Start Your
Engine” before using the pressure washer.
Connect High Pressure
Hose Here
Figure 5 — Connect High Pressure Hose to Spray Gun
Figure 6 — Connect High Pressure Hose to Water Outlet
Inspect inlet
screen. Do
Not use if
damaged;
clean if dirty.
Figure 7 — Connect Garden Hose to Water Inlet
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Commentaires sur ces manuels

Pas de commentaire