Brute Pressure Washer Manuel du propriétaire télécharger pdf (Page 10)

Generac Portable Products 2100 PSI Pressure Washer

To apply detergent, follow these steps:

• Review the use of adjustable nozzles.

• Prepare detergent solution as required by the job.

• Hang the detergent solution on the hook of the

wireform attached to the handle, as shown in Figure 15.

• Place the small filter end of the detergent siphoning tube

into the detergent container.

CAUTION! Keep the detergent siphoning tube from

coming in contact with the hot muffler. This will damage

the plastic tube. When inserting the filter into a cleaning

solution bottle, route the tube so as to keep it from

inadvertently contacting the hot muffler.

• Make sure the garden hose is connected to the water

inlet. Check that the high pressure hose is connected to

the spray gun and the pump.

• Start the engine and attach nozzle extension.

• Slide the adjustable nozzle forward to low pressure

mode. Detergent cannot be applied with the nozzle in

high pressure position.

• Apply detergent to a dry surface, starting from the

bottom and working up.

• Allow the detergent to “soak in” for 3-5 minutes before

washing and rinsing. Reapply as needed to prevent

surface from drying.

• For washing, start at lower portion of area to be washed

and work upward, using long, even, overlapping strokes.

Pressure Washer Rinsing

WARNING: Be extremely careful if you must use

the pressure washer from a ladder, scaffolding or

any other relatively unstable location. Pressure in a

running washer builds as you climb. When you

press the trigger, the recoil from the initial spray

could cause you to fall. The high pressure spray

could also cause you to fall if you are too close to

the cleaning surface.

For Rinsing:

• Slide the nozzle backward to high pressure, press the

trigger and wait for the detergent to clear.

NOTE: You can also stop detergent from flowing by

simply removing detergent siphon tube from bottle.

• Keep the spray gun a safe distance from the area you

plan to spray.

• Apply a high pressure spray to a small area, then check

the surface for damage. If no damage is found, it is okay

to continue cleaning.

• Start at the top of the area to be rinsed, working down

with same overlapping strokes as you used for washing

and applying detergent.

Automatic Cool Down System

(Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun,

circulating water in the pump can reach a temperature

between 125°–155°F. When the water reaches this

temperature, the automatic cool down system engages and

cools the pump by discharging the warm water onto

the ground. This system prevents internal damage to the

pump.

Figure 15 — Insert Filter into Container

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Brute Pressure Washer Manuel du propriétaire Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Nettoyeurs haute pression Brute Pressure Washer